Unpacking And Assembly - Ruris Rx Pilot 001M Bedienungsanleitung

EN
Carefully inspect the entire work area and remove any objects (rocks, branches, wire, bones, etc.) that
could be thrown or damaged by the machine.
Stay away from the exhaust vent.
Do not detach, disable, remove or modify installed safety systems/micro switches.
Pay close attention to sloping terrain and be extra careful to prevent overturning or loss of control. The main
reasons for loss of control are:
- Insufficient wheel grip.
- The speed is too high.
- A sudden change of direction.
- Insufficient braking.
When moving away from the tractor and when inspecting the tractor be sure to turn off the engine and
remove the ignition key to ensure that all moving parts have come to a complete stop:
If the machine starts to vibrate abnormally: check for possible damage; Check and tighten any loose parts.
All inspections, repairs and replacements are carried out by an authorized RURIS service center.
Do not touch engine parts and areas that heat up during operation. There is a risk of burns.
To avoid fire hazards, do not leave the machine in tall grass while the engine is running.
Never use the machine with worn or damaged parts. Defective or worn parts must always be replaced and
never repaired. Only original RURIS spare parts are used.
To avoid the risk of fire, check regularly for oil or fuel leaks.
IMPORTANT! Unpacking and assembly operations must be performed on a flat, stable surface with
sufficient space for handling the machine and packaging, using appropriate tools.
1. Open the package carefully and do not lose the components.
2. Check the documentation in the box, including these instructions.
3. Remove all parts from the box.
4. Take the following precautions when unpacking the device:
- Move the machine's cutting assembly to its maximum height to prevent damage when the machine is
lowered;
- Lower the machine from the base plate.
8

5. UNPACKING AND ASSEMBLY