IKEA SKINANDE Bedienungsanleitung Seite 19

ENGLISH
Problem and alarm code
The salt indicator continues
to stay on after replenish-
ment of the salt container.
Once you have checked the appliance,
deactivate and activate the appliance. If
the problem occurs again, contact an
Authorised Service Centre.
The washing and drying results are not satisfactory
Problem
Poor washing results.
Poor drying results.
There are whitish streaks or
bluish layers on glasses and
dishes.
There are stains and dry wa-
ter drops on glasses and
dishes.
• If after 3 or 4 programmes, the salt indicator continues to
stay on, contact the service.
This can occur when you are using salt that needs more
time to dissolve.
There in no unwanted effect on the performance of the
appliance.
For alarm codes not described in the table,
contact an Authorised Service Centre.
Possible cause and solution
• Refer to "Daily use", "Hints and tips" and basket
loading leaflet.
• Use more intensive washing programmes.
• If you use multi-tablets, always switch on the option
Multitab.
• Clean spray arm jets and filter. Refer to "Care and
Cleaning".
• Tableware has been left for too long inside a closed
appliance.
• There is no rinse aid or the dosage of rinse aid is not
enough. Set the rinse aid dispenser to a higher level.
• Plastic items may need to be towel dried.
• We recommend to always use rinse aid, even in com-
bination with multi-tablets.
• The release quantity of rinse aid is too much. Adjust
the rinse aid level to a lower level.
• The quantity of detergent is too much.
• The released quantity of rinse aid is not sufficient. Ad-
just the rinse aid level to a higher level.
• The quality of the rinse aid can be the cause.
Possible solution
19