6. After drying the replaceable MicroMesh™ ultra-fine filter and filter box, install the
filter in the filter box, and insert the filter box back into the device.
Ensure that A on the filter box is
aligned with A on the replaceable
MicroMesh™ ultra-fine filter.
After installation, check whether the
rubber strip is all stuck into the limiting
slot.
Notes:
•
After each cleaning task, promptly remove the device from the pool and clean the
filter box immediately. Avoid leaving the device in the pool for extended periods.
•
Drying the replaceable MicroMesh™ ultra-fine filter and filter box after each
cleaning is not required and is recommended solely to prevent moisture-related
odors.
•
When drying or storing your device, including the replaceable MicroMesh™ ultra-fine
filter and filter box, it's recommended to store them in a well-ventilated area, out of
direct sunlight.
•
The replaceable MicroMesh™ ultra-fine filter can trap particles as small as 3-10 m,
such as silt and some algae. When visible debris is minimal (e.g., stones, leaves,
sand, debris, hair) and the water appears cloudy or some algae, it is recommended
to use both the filter box and the replaceable MicroMesh™ ultra-fine filter. If there is
a significant amount of visible debris, it is recommended to use only the filter box
and not use the replaceable MicroMesh™ ultra-fine filter.
A
A
B
C
Pull up the four corners A, B, C, and D
on the rubber strip in turn. Ensure that
they are stuck in the limiting slot of the
replaceable MicroMesh™ ultra-fine
filter.
165
D