Herunterladen Diese Seite drucken

Scheppach 7906100720 Originalbetriebsanleitung Seite 17

Druckluft-sandstrahlpistole
Vorschau ausblenden Andere Handbücher für 7906100720:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
• Keep your hands away from the working area when
the product is in operation.
7.
Technical data
Max. working pressure
Air consumption
Dirty water
Volumetric flow rate
Required air quality
Subject to technical changes!
Noise and vibration
m Warning: Noise can have serious effects on your
health. If the machine noise exceeds 85 dB, please
wear suitable hearing protection.
Information about noise level measured in accord-
ance with EN 14462
Noise data
Sound power level L
WA
Sound pressure level L
pA
Uncertainty K
wa/pA
Vibration parameters
Vibration value according to EN 14463-1
Vibration a
h
WARNING! The vibration level specified in this ins-
truction has been measured based on a measure-
ment procedure standardised in EN 60335-14463-1
and can be used for unit comparison. The specified
vibration emission value can also be used for an initial
estimation of the exposure. The vibration level will va-
ry depending on the use of the tool and may in some
cases be higher than the value specified in these ins-
tructions. The vibration load could be underestimated
if the tool is regularly used in such a way.
NOTE! For an accurate estimation of the vibration ex-
posure during a given working period, the times when
the device is switched off or running but not actually
in use should also be taken into account. This can
significantly reduce the vibration load over the entire
working period.
8. Unpacking
• Open the packaging and carefully remove the prod-
• Remove the packaging material, as well as the pack-
3.5 bar
• Check whether the scope of delivery is complete.
113 l/min
• Check the product and accessory parts for transport
850 ml
200 g/min
cleaned, free of oil
• If possible, keep the packaging until the expiry of the
• Familiarise yourself with the product by means of the
• With accessories as well as wearing parts and re-
• When ordering please provide our article number as
m WARNING!
The product and the packaging material are not
children's toys! Do not let children play with plas-
103 dB
tic bags, films or small parts! There is a danger of
92 dB
choking or suffocating!
3 dB
9.
m Attention!
Always make sure the product is fully assembled
<2.5 m/s²
before commissioning!
Connect compressed air source
NOTE! The product may only be operated with clea-
ned, condensate and oil-free compressed air and must
not exceed the maximum working pressure of 3.5 bar
at the device. To enable you to regulate the air pres-
sure, the compressed air source must be equipped
with a (filter) pressure reducer.
Filling the blasting material container
ATTENTION! Before you open the screw cap (7) of
the blasting material container (6) or make any other
adjustment, the compressed air hose must be discon-
nected and the pressure must be completely released.
www.scheppach.com
uct.
aging and transport safety devices (if present).
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
warranty period.
operating manual before using for the first time.
placement parts use only original parts. Spare parts
can be obtained from your specialist dealer.
well as type and year of manufacture for the product.
Start-up
Connect the compressed air sandblasting gun to a
suitable compressed air source by connecting the
quick coupling of the supply hose to the plug nipple
(2) on the compressed air sandblasting gun. The
locking mechanism is automatic.
GB | 17

Werbung

loading