Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Fitting the propeller
Install the propeller on the motor as shown in the photo, using a 1.5 mm Ø steel rod
to tighten the spinner. Caution: fit the propeller with the lettering facing forward, i.e.
towards the model's nose. If you fit it the other way round, motor power will be greatly
reduced.
The model is designed primarily for use with a two-cell LiPo battery, but if you wish to
use a three-cell pack, e.g. Order No. 7634.3BEC, fit the alternative CAM SLIM PROP
15 x 7.5 cm propeller (30), which is also supplied in the kit.
Decals
It is not necessary to paint the model's SOLIDPOR® components. If you wish to give
the aircraft a coloured finish, we recommend the use of GRAUPNER LEXACOLOR
spray paints, Order No. 945... Do not rub down the surfaces prior to painting; instead
wipe them with cellulose thinners, Order No. 1409, and a piece of absorbent paper
towel.
Cut out and apply the decals from the decal sheet (28) to complete the construction
of the model.
Balancing
Assemble the model completely, with all the RC system components and power
system in place.
The Centre of Gravity range is 75 mm to 85 mm aft of the wing root leading edge;
you will need to fit nose ballast (Order No. 536) to achieve this. Support the model at
the stated CG position with two fingers under the wing roots, and allow it to hang
freely: the fuselage will hang level when balanced correctly.
Flying
Wait for a day with little or no breeze for the initial test-flight. The ideal flying site is a
grassy field with a gentle slope facing into wind. Check that the control surfaces are
exactly at centre before flying.
Switch the motor on and give the aeroplane a hand-launch exactly into any
breeze; trotting forwards for a few steps gains the necessary momentum. The
model's nose should be angled up slightly (around 15° ) for a launch under
power.
Initially use the controls just to correct any deviations from a straight flight path. Fine-
tuning can be carried out by adjusting the trim sliders or buttons situated below and
next to the transmitter sticks. Always land the model directly into wind, with the motor
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler! Id.-Nr. 0060560 12/2009
- 26 -
Werbung
