Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Use the same procedure to glue the elevator servo in the left-hand fuselage shell (2).
Check from the transmitter that both servos still work correctly.
Fix the motor (1) to the motor mount (8) using the two screws (9). Tighten the screws
fully, and secure each one with a drop of cyano.
The motor mount (8) can now be glued in the right-hand fuselage shell. Press the
cables into the channel, and secure them with a little glue.
If necessary, shorten the motor cables by deploying them in a curve - as shown in the
photo - so that the BRUSHLESS CONTROL 18 speed controller lies flat on the
fuselage. Tack the speed controller in place with a little adhesive. Connect the power
system - but without fitting the propeller - and check that it functions properly,
referring to the instructions supplied with the power set.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler! Id.-Nr. 0060560 12/2009
- 21 -
Werbung
