Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The illustration shows the small ABS parts included in the kit. Do not remove these
components from the sprue until you actually need them.
Note: the small ABS parts are also available as a replacement set under Order No.
4218.5.
Unscrew the original output levers from the C231 servos, and set the servos to centre
(neutral) from the transmitter. Mount parts (5) to (9) on the servo output arms (6) as
shown in the photo. Tighten the nuts just to the point where the swivel pushrod
connectors rotate smoothly, but without lost motion.
Screw the servo output arms to the servos in the arrangement shown in the picture.
The photo shows the prepared servos, ready for fitting, with the rudder servo on the
left. The spare output arms also shown in the picture are not required for this model.
Fix the rudder servo in the right-hand fuselage shell (1) with a single drop of cyano on
each mounting lug and one on the underside of the servo case.
Caution: do not use thin cyano, or too much cyano of any type, as it could
penetrate the case and jam the moving parts.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler! Id.-Nr. 0060560 12/2009
- 20 -
Werbung
