Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Limitation by lapse of time
If we do not acknowledge the validity of a claim based on this declaration within the claim
period, all claims based on this declaration are barred by the statute of limitations after six
months from the time of implementation; however, this cannot occur before the end of the
claim period.
Applicable law
This declaration, and the claims, rights and obligations arising from it, are based exclusively
on the pertinent German Law, excluding the norms of international private law, and excluding
UN retail law.
Introduction
The ELEKTRO-ROOKIE S is a radio-controlled model aircraft with an excellent
performance, designed specifically for the beginner to the hobby. For safety reasons
its all-up weight should not exceed 800 g.
RC accessories (not included)
To fly this model you will need an FM radio control system such as the X-412 or an
iFS set. For more information regarding RC equipment please refer to the main
GRAUPNER FS catalogue.
X-412 FM radio control set, 35 MHz*
*In Germany the 35 MHz frequency band is reserved exclusively for model aircraft.
LiPo Balancer charger
C231 servo (two required)
LiPo flight battery, 2/2500 7.4 V BEC, 20C
Ballast weight
Tools and adhesives (not included)
Balsa knife
Slot-head screwdriver
Cross-point screwdriver
Cyano-acrylate glue ("cyano")
Cyano activator
You will also need the following items: flat-nose pliers, paper scissors, 1.5 mm steel
rod, adhesive tape, kitchen paper, protective gloves, protective goggles.
Building Instructions
Please start by reading right through these building instructions, so that you gain an
overall understanding of how the model goes together. Lay out the components
required for each stage of construction, together with the tools and adhesives. When
working on the model always keep the bench surface clean and smooth, or cover it
with a sheet of soft foam; this avoids damage to the model's surfaces. Unless stated
otherwise, use cyano-acrylate glue ("cyano") and activator ("kicker") for all joints on
this model. The best method is to apply adhesive to one side of the joint, and spray
activator on the mating surface. Please take particular care to avoid adhesive getting
on your hands or the surface of the model: wipe off excess glue immediately using
kitchen paper (paper towel).
Caution: cyano-acrylate adhesives must not be allowed to come into contact
with any part of your body, and especially not your eyes. For this reason we
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler! Id.-Nr. 0060560 12/2009
Order No. 4713
Order No. 6454
Order No. 5109.LOSE
Order No. 7633.2BEC
Order No. 536
Order No. 980
Order No. 5781.4
Order No. 5779.0
Order No. 5821
Order No. 953.150
- 18 -
Werbung
