Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The tailplane
Cut away the unwanted foam at both ends of the elevator, and move the control
surface repeatedly in both directions to free up the integral hinge. Glue the spreader
plate (21) to the top of the tailplane as shown, and glue the horn (15) in the slot in the
underside of the elevator.
The control surface linkages
Cut off the excess length of the snake outer sleeves (4) at the tail end of the
fuselage.
Slip the rudder pushrod (16) into the outer sleeve from the tail end, and slip the front
end through the swivel pushrod connector (5) mounted on the right-hand servo.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler! Id.-Nr. 0060560 12/2009
- 23 -
Werbung
