Werbung
Verfügbare Sprachen
Verfügbare Sprachen
recommend that you wear protective gloves and goggles when building the
model. Your workshop should be well ventilated in order to allow adhesive
fumes to disperse. Store all glues well out of the reach of children. Do not use
adhesives such as foam-safe cyano, white glue (PVA) or epoxy resin for this
model, as none of them produces strong joints between SOLIDPOR® high-
density foam and any other material.
Take the time to read through the operating instructions for the BRUSHLESS
CONTROL 18 speed controller, which is supplied in the motor set.
Fuselage and fin
You will find a strip of foam linking the bottom edge of the rudder to the fuselage; cut
this away, and move the rudder repeatedly from side to side to free up the integral
hinge line.
Glue the fuselage stiffening tube (3) in the right-hand fuselage side (1), followed by
the two "snake" outer sleeves (4), noting that the sleeve for the rudder should be
fitted first; it must project by 15 mm at the front end.
Caution: do not cut off the excess length of the snake sleeves (4) at the tail end, as
this might allow excess cyano to run inside them.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler! Id.-Nr. 0060560 12/2009
- 19 -
Werbung
