Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Connect the speed controller to socket I of the receiver, the rudder servo to socket II,
and the elevator servo to socket III. Deploy the servo leads neatly under the receiver.
The receiving system is switched on by completing the BEC connection, as shown in
the photo. Bind the receiver to the transmitter using the procedure outlined in the
manual supplied with your RC system. Check the direction of motor rotation: if the
propeller spins clockwise when viewed from the tail, disconnect the push-button (top
of picture) from the speed controller.
Checking the control surfaces
The stick mode at the transmitter should be set as shown in the photograph: throttle
(motor speed) and direction (rudder) on the right-hand stick. Stick back (towards you)
equates to motor off; stick forward means full power. Elevator control should be on
the left-hand stick: pulling the stick back deflects the elevator up; pushing it away
from you produces down-elevator. If either function works the wrong way round, use
your transmitter's servo reverse facility to correct that channel.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler! Id.-Nr. 0060560 12/2009
- 25 -
Werbung
