Scheppach BTS800 Original Bedienungsanleitung Seite 30

- Up to three waste electrical devices per type of
device, with an edge length of no more than 25
centimetres, can be returned free of charge to
the manufacturer without prior purchase of a new
device from the manufacturer or taken to another
authorised collection point in your vicinity.
- Further supplementary take-back conditions of
the manufacturers and distributors can be ob-
tained from the respective customer service.
• If the manufacturer delivers a new electrical appli-
ance to a private household, the manufacturer can
arrange for the free collection of the old electrical
appliance upon request from the end user. Please
contact the manufacturer's customer service for
this.
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal of
waste electrical and electronic equipment.
15. Troubleshooting
Problem
Motor doesn't start
Machine gets slower
during work.
Sanding belt comes
off the drive pulleys.
The wood gets burnt
during sanding.
30 | GB
Possible cause
a) ON/OFF switch damaged.
b) ON/OFF cable damaged.
c) ON/OFF relay damaged.
d) Fuse blown.
e) Motor burnt.
Too much pressure put on the
workpiece.
Belt does not run straight.
a) Sanding disc or belt covered
with grease.
b) Excessive pressure on
workpiece.
www.scheppach.com
Help
a-d) Replace all damaged parts
before you use your machine
again.
e) Contact your local service cen-
tre. Every attempt to carry out a
repair, can be dangerous if it is
not done by skilled personnel.
Reduce the pressure on the workpiece.
Reset the track.
a) Replace disc or belt.
b) Reduce pressure on workpiece.