Scheppach CB01 Originalbetriebsanleitung Seite 15

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new device brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this device assumes no liability for
damage to the device or caused by the device arising
from:
• Improper handling,
• Failure to comply with the operating instructions,
• Repairs carried out by third parties, unauthorised
specialists,
• Installing and replacing non-original spare parts,
• Application other than specified,
Note:
The operating manual is part of this product.
It includes important instructions for the safe, proper
and economic operation of the product, for avoiding
danger, for minimising repair costs and downtimes and
for increasing the reliability and extending the service
life of the product. In addition to the safety instructions
in this operating manual, you must also observe the
regulations applicable to the operation of the product
in your country.
Familiarise yourself with all operating and safety in-
structions before using the product. Only operate the
product as described and for the specified areas of ap-
plication. Keep the operating manual in a good place
and hand over all documents when passing the product
on to third parties.
2. Device description (Fig. 1 - 4)
1. Load chain
2. Hand chain
3. Fastening hooks
4. Load hook
5. Load pin
6. Drive wheel
7. Snap lock
3. Scope of delivery
• Chain hoist
• Operating manual
4. Proper use
The chain hoist is a device used to lift and lower loads
vertically.
The chain hoist is designed for a slinging height (dis-
tance between slinging point and base plate) of 3.0 -
3.5 metres. Outside of this slinging height, the hand
chain must be shortened or lengthened accordingly.
The machine may only be used in the intended manner.
Any use beyond this is improper. The user/operator, not
the manufacturer, is responsible for damages or inju-
ries of any type resulting from this.
Please note that our equipment was not designed with
the intention of use for commercial or industrial purpos-
es. We assume no guarantee if the device is used in
commercial or industrial applications, or for equivalent
work.
5. Safety instructions
1. The nominal load limit must not be exceeded, as
overloading can damage the chain hoist or reduce
its lifting capacity in the future.
2. Do not use any electrical appliances to operate the
chain hoist. This chain hoist is designed for manu-
al operation only.
3. Do not attempt to repair the load chain. If dam-
aged, the load chain may only be replaced by a
specialist. The load chain must be replaced with a
new chain of the same welded and hardened steel,
of the same size and the same strength.
4. Please lubricate the load chain before use.
5. The brake surfaces must not be lubricated. The
brake must be kept dry.
6. Ensure that the load chain is not knotted. If there
are knots in the load chain, they must be untied
before use.
7. Ensure that the load chain is hooked to the load
end pin before each use.
8. Stand in the same position and at the same angle
to the drive wheel when pulling the hand chain.
Please do not pull at an angle. It is necessary to
take up a secure position.
9. Do not lift the load above people. Do not allow any-
one to step under the load. If you are planning to lift
a load, please warn people in the surrounding area.
www.scheppach.com GB | 15