Cutting Blade - Honda HRD536CTXEA Betriebsanleitung

DRIVE CLUTCH LEVER CLEARANCE
Measure the clearance [1] at
the tip of the lever [2] when
completely released.
The clearance must be between:
HRD536C TXEA
1 - 5 mm
2
3
1
IF NECESSARY:
1. Undo the lock nuts [3] with a 10 mm
spanner.
2. Move the nuts [3] up or down as
necessary.
3. Tighten the nuts and check the
clearance again.
SHIFT LEVER ADJUSTMENT
1. Put the shift lever [4] in the fastest
position.
2. Undo the lock nuts [5] with a 10 mm
spanner.
3. Tighten or undo the nuts [5] so as to
obtain a clearance of between
1.5 mm and 6.5 mm at the clutch
lever [6], then tighten the nuts.
4. Start the engine and check that the
minimum and maximum speeds
correspond to the following values:
Minimum = 0 ~ 0.2 m/s
Maximum = 1.3 m/s at an engine speed
of 2 800 rpm.
10 EN
[1]
[2]
HRD536C HXEA
1.5 - 6.5 mm
[3]
[3]
[4]
[5]
[5]
[6]
2
3
1
SHIFT LEVER ADJUSTMENT
Pull the shift lever [7] back completely
and release it. It should position itself
opposite the "1" on the control cover.
If necessary:
1. Undo the lock nuts [8] using a
10 mm spanner and tighten/undo
the tensioner [9] as required.
2. Tighten the lock nuts and check the
alignment.
3. Check that the lever moves freely.
4. Start the engine and check that the
gears "1", "2" and "3" engage
correctly.
Readjust if necessary.

CUTTING BLADE

BLADE REMOVAL
1. Place the throttle control lever in
"STOP" position.
2. Close the fuel shut-off valve and drain
the carburettor.
3. Tip the mower so that the carburettor faces upwards.
NOTE: Never tip the mower so that the carburettor faces down; this
will make starting difficult.
4. Remove the
blade [11] bolts [14]
with a 14 mm [13]
socket spanner. Use
a block of wood to
prevent the blade
from turning when
undoing the bolts.
5. Remove the blade
from the blade
holder [12] together
with the block.
BLADE SHARPENING
1. Sharpen the blade cutting edges
with a file. File the top side only.
Maintain the original bevel for a fine
cutting edge. File both ends evenly
to maintain blade balance.
2. After sharpening, test the blade's
balance using a screwdriver as
shown. If either side dips slightly
below the horizontal, file that side.
Replace the blade if it dips
excessively.
CAUTION:
• Blade balance is critical to proper mower performance. Replace
any blade that is damaged or out of balance.
• Use only a genuine Honda replacement blade or equivalent.
SAFETY
[11] [12]
[10]
U
[14]
MAX
mm
15
[7]
[8]
[9]
B3 C18
D7 D8 D9
[13]