Werbung
➢ Before initial operation, please check that all components are present and that
they are not visibly damaged.
2.2 Unpacking / site
1. Unpack the appliance carefully. Dispose of the packaging as described in chapter
waste management.
2. The appliance must not build in.
3. Completely remove the transport-protection. Be very careful and do not use any
aggressive or abrasive detergents to remove residuals of the transport-protection.
4. Check that the appliance and the power cord are not damaged.
5. Do not install the appliance in a bathroom or a place where it may come in
contact with water or rain; otherwise, the insulation of the electrical system will
be damaged. Do not install the appliance in a room where explosive or flammable
gases are stored.
6. Protect the appliance from direct sunlight.
7. Install the appliance in a dry and well-ventilated place. The room temperature
must be higher than +5°C.
8. Install the appliance in a suitable position with an adequate distance from sources
of heat and cold.
9. ATTENTION: Leave the appliance in an upright position for 4-6 hours before
you switch it on to ensure that the oil has flowed back into the compressor.
10. Do not install the appliance on a carpet / fitted carpet.
11. Install the appliance on a level, dry and solid floor. Check the correct installation
with a bubble level.
12. Connect the appliance to the mains properly.
13. The nameplate is situated at the back of the appliance.
~
~
57
Werbung
