SOMFY RU Basic 28 WF RTS Li-ion II Anleitung Seite 6

EN
2.1.3.Assembling the drive-tube
1] Slide the drive into the tube. Insert the
wheel by aligning the wheel to the tube
profile. Insert the drive half way and then
slide the crown down the drive and insert
it in the tube. Finally, push the motor
inside the tube.
2] Not required, but if needed, fix the tube to
the drive with self-tapping screws or steel
pop rivets depending on the dimension (L).
2.1.4.Mounting the tube-drive assembly on the brackets
(a) Standard bracket.
(b) Drive plate for specific bracket.
NOTICE
For optimal radio reception, the motor
antenna should be kept straight and should be
positioned outside of headrail (if used).
2.2.Wiring
PRECAUTION
• To ensure electrical safety, this Class III motor must be powered by a «SELV»
voltage source (Safety Extra Low Voltage).
• The battery level must be below 30% before shipping by air.
WARNING
• Use power charger (recommended by Somfy) to charge the drive battery.
• Ensure battery is fully charged prior to installation on site.
• Before setting, it is necessary to charge the battery only if the LED blinks red
5 times when you press any button on the paired control point.
1] Connect the charger to the drive.
6
©
Copyright 2020 SOMFY ACTIVITES SA. All rights reserved.
RU Basic 28 WF RTS Li-ion II
1]
2]
(a) (b)