SOMFY RU Basic 28 WF RTS Li-ion II Anleitung Seite 20

EN
1] If the drive is fixed to the tube, disassemble
the motorised product to access the self-
tapping screws or steel pop rivets (drive
wheel side) and remove them.
2] Grab the motor head and pull out the
drive by sliding it out of the motorised
product tube.
3] If necessary, offset the ring gear on the
actuator tube to access the two T6 torx
screws or cruciform screws and unscrew
the motor head.
4] Remove carefully the motor head from
the tube taking care not to damage the
wires and disconnect the battery.
5] Grab and remove the used battery by
sliding it out of the tube taking care not to
damage the wires.
6] Insert and slide the new battery into the
drive tube, leaving the battery connector
accessible from the outside of the tube.
7] Connect the new battery.
8] Insert the motor head using the keying
notches on the drive tube taking care not
to cut off the wires.
9] Screw the motor head using the two T6
torx screws or cruciform screws to the
drive tube.
➔ Restart the installation referring to Assembling
the drive-tube.
NOTICE
if necessary, readjust the end limits referring
to Readjusting the end limits [
20
} 11]
©
Copyright 2020 SOMFY ACTIVITES SA. All rights reserved.
RU Basic 28 WF RTS Li-ion II
1]
2]
3]
4]
5]
6]
7]
8]
9]