ZANKER ZKK 8417 K Benutzerinformation Seite 24

2
1
Install the appliance in
the niche.
Push the appliance in the
direction of the arrows (1)
until the upper gap cover
stops against the kitchen
furniture. Make sure that
the distance between the
appliance and the cup-
board front-edge is 44
mm.
Push the appliance in the
direction of the arrows (2)
against the cupboard on
the opposite side of the
hinge. Make sure that the
clearance between the
appliance and the cup-
board is 4 mm.
Remove the correct part
from the hinge cover (E).
Make sure to remove the
part DX, in the case of
right hinge, SX in oppo-
site case.
24
4mm
44mm
Adjust the appliance in
the niche.
The lower hinge cover (in
the accessories bag)
makes sure that the dis-
tance between the appli-
ance and the kitchen fur-
niture is correct.
Open the door. Put the
lower hinge cover in posi-
tion.
C
D
E
E
B
Attach the covers (C, D)
to the lugs and the hinge
holes.
Install the vent grille (B).
Attach the hinge covers
(E) to the hinge.
I
I
Attach the appliance to
the niche with 4 screws.
G
H
Connect the appliance lat-
erally to the kitchen furni-
ture sidewall:
1. Loosen the screws of
the part (G) and
move the part (G) till
the furniture sidewall.
2. Tighten the screws of
the part (G) again.
3. Attach the part (H) to
the part (G).
Push the sealing strip be-
tween the appliance and
the adjacent cabinet.
Ha Hb
Hc
Hd
Disconnect the parts
(Ha), (Hb), (Hc) and (Hd).