Technical Data; Installation - ZANKER ZKK 8417 K Benutzerinformation

Problem
Replacing the lamp
Caution! Disconnect the plug from the mains
socket.
1. Remove the
screw from the
lamp cover.
2. Remove the lamp
cover (refer to the
illustration).
3. Replace the used
lamp with a new
lamp of the same

Technical data

Dimension of the recess
Rising Time
The technical information are situated in the rating
plate on the internal left side of the appliance and in
the energy label.

Installation

Caution! Read the "Safety Information"
carefully for your safety and correct operation of
the appliance before installing the appliance.
Positioning
Install this appliance at a location where the ambient
temperature corresponds to the climate class indica-
ted on the rating plate of the appliance:
22
Possible cause
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
Height
Width
Depth
Store less products at the same time.
Make sure that there is cold air circu-
lation in the appliance.
power and specifically designed for household ap-
pliances (the maximum power is shown on the
lamp cover).
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door. Make sure that the light comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets.
Contact the Service Center.
1580 mm
560 mm
550 mm
20 h
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Solution