Electrical Connection; Door Reversibility; Ventilation Requirements; Installing The Appliance - ZANKER ZKK 8417 K Benutzerinformation

Electrical connection

Before plugging in, ensure that the voltage and fre-
quency shown on the rating plate correspond to your
domestic power supply.
The appliance must be earthed. The power supply ca-
ble plug is provided with a contact for this purpose. If
the domestic power supply socket is not earthed, con-
nect the appliance to a separate earth in compliance
with current regulations, consulting a qualified electri-
cian.
• Loosen the upper pin
and remove the
spacer.
• Remove the upper pin
and the upper door.

Ventilation requirements

The airflow behind the
appliance must be suffi-
cient.
• Loosen the middle
hinge.
min.
50 mm
2
200 cm
min.
200 cm 2
The manufacturer declines all responsibility if the
above safety precautions are not observed.
This appliance complies with the E.E.C. Directives.

Door reversibility

The door of the appliance opens to the right. If you
want to open the door to the left, do these steps be-
fore you install the appliance:
• Remove the lower
door.
• Loosen the lower pin.

Installing the appliance

Caution! Make sure that the mains cable can
move freely.
Do the following steps:
On the opposite side:
• Install the lower pin.
• Install the lower door.
• Tighten the middle
hinge.
• Install the upper door.
• Tighten the spacer
and tighten the upper
pin.
23