Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
8.3.7 Device Setting
1.Enter the Setting page
2. Device Information
• Device Name
• Device SN
3. General Setting
• Device Information: More information.
• Network Setup: Reconfigure the network.
• Instruction Manual: Electronic version of the product manual.
4. Commom Setting
• On-grid Settings
-On-grid input mode： Specify the AC charging power (constant power
charging)
-On-grid output mode：Specify the AC discharging power (constant
power discharging)
-Set the regulatory output limit power: The system will not exceed this
safety output valuein any working state, ensuring the safety of your
home wiring.
• Battery Setting
Adjust the battery discharge limit and charging limit.
• Grid-connected Standards
Select according to the national standards used at the
equipment installation site, and switch
the voltage and frequency of the equipment charging and
discharging.
• Power Distribution Strategy
Understand the priority of solar energy flow distribution
within the system.
Set whether to allow excess energy export.
-Allow: After the battery is full, permit the solar power
exceeding household demands to
backfeed into the grid.
-Forbidden: After the battery is full, it doesn't permit solar
power exceeding household
demands to backfeed into the grid.
• Firmware update
Make sure your device has configured Wi-Fi and has a stable
network connection.
If there is an important update for the firmware of SolarFlow
800 Pro, the app will guide you to through the process. Make
sure your devices are on and connected to Wi-Fi before
updating.
5.Remove Device
Remove the connection between the device and the App.
If you need to control the device using the App again, you
need to add the device again.
18
Werbung
