Troubleshooting - AEG HC452600EB Benutzerinformation

32 www.aeg.com

7. TROUBLESHOOTING

You cannot activate the
appliance or operate it.
A sound operates when
the appliance is deacti-
vated.
The residual heat indica-
tor does not come on.
A sound operates and
appliance activates and
deactivates again. After
5 seconds one more
sound operates.
comes on
and number come
on.
There is no signal when
you touch the panel sen-
sor fields.
If you tried the above solutions and can-
not repair the problem, speak to your
dealer or the Customer Care Depart-
Problem
• Do not use the scraper or sharp ob-
jects to clean the glass bar and the
space between it and glass ceramic.
Glass bar is attached to the ceramic
plate.
• Do not put the pots on the glass bar.
• Make sure that the pans and pots do
not touch the glass bar.
Possible cause and remedy
• You touched 2 or more sensor fields at the same
time. Only touch one sensor field.
• There is water or fat stains on the control panel.
Clean the control panel
• Activate the appliance again and set the heat set-
ting in 7 seconds.
• The Child Safety Device or the lock operates. See
the chapter Daily use.
You put something on one or more sensor fields.
Remove the object from the sensor fields.
The cooking zone is not hot because it operated
only for a short time. If the cooking zone must be
hot, speak to the service centre.
You put something
sensor field.
The Automatic Switch Off operates. Deactivate the
appliance and activate it again.
There is an error in the appliance.
Disconnect the fuse from the electrical system of
the house in order to disconnect the appliance from
the electrical supply for some time. Connect again.
If comes on again, speak to the service centre.
The signals are deactivated.
Activate the signals (see OffSound Control ).
ment. Give the data from the rating
plate, three-digit-letter code for the
glass ceramic (it is in the corner of the
. Remove the object from the