HASE ELVAS Bedienungsanleitung Seite 35

Table of contents
1. General Information
2. Control Elements
1.1 Definition of Safety Notes
3. Safety distances
4. Connection of Multiple Devices in
Direct Vent Operation
5. Fuel Load Sizes and Thermal Output
5.1 Wood Briquettes
6. Operating the Revolving Console
7. Initial Operation
8. Lighting the Fire
9. Adding Fuel / Heating at Nominal
Thermal Output
10. Heating at Low Thermal Output
(during Transitional Seasons)
11. Emptying the Ash Drawer
12. Disposing of the product
13. Technical Data
Annex
Technical documentation
Product data sheet
Type label
EC declaration of conformity
Energy efficiency label
1. General Information
35
The installer and operator must read the operating
36
instructions prior to installing and using the stove.
36
37
Failure to observe the operating and installation
instructions will void the warranty. Any structural
38
modifications to the stove by the operator is
38
prohibited.
38
The following regulations and documents must be
38
observed when installing and removing the
39
40 fireplace, connecting the combustion air controller
and during operation:
40
► Building code.
41
► Chimney calculations as per DIN
41
EN 13384-1 and DIN EN 13384-2.
41
► Technical documentation for the stove.
42
► Local ordinances as well as all
necessary, applicable national and
European standards.
87
Keep the operating instructions in a safe location
92
near your stove.
94
95
Please note and observe all warnings and safety
99
notes.
Always use original replacement parts.
Failure to observe these operating instructions will
void all liability and warranty claims.
The graphics and images used in this document are
intended for illustration purposes only and are not
to scale.
All texts, images, graphics and contents of these
operating instructions are protected by copyright.
These must not be altered, copied, duplicated or
published in whole or in part without prior written
approval.
Technical changes and misprints reserved.
© HASE Kaminofenbau GmbH
en
35