Scheppach DH8000x Originalbetriebsanleitung Seite 18

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new device brings you much enjoy-
ment and success.
Note:
In accordance with the applicable product liability
laws, the manufacturer of this device assumes no
liability for damage to the device or caused by the
device arising from:
• Improper handling,
• Failure to comply with the operating instructions,
• Repairs carried out by third parties, unauthorised
specialists,
• Installing and replacing non-original spare parts,
• Application other than specified,
• Failures of the electrical system in the event of the
electrical regulations and VDE provisions 0100,
DIN 57113 / VDE0113 not being observed.
Note:
The operating manual is part of this product. It in-
cludes important instructions for the safe, proper and
economic operation of the product, for avoiding dan-
ger, for minimising repair costs and downtimes and
for increasing the reliability and extending the service
life of the product. In addition to the safety instructions
in this operating manual, you must also observe the
regulations applicable to the operation of the product
in your country. Familiarise yourself with all operating
and safety instructions before using the product. Only
operate the product as described and for the speci-
fied areas of application. Keep the operating manual
in a good place and hand over all documents when
passing the product on to third parties.
2. Device description (Fig. 1 - 6)
1. Handle
1a. Hexagonal bolt M6x35mm
2. Flap (dust filter)
2a. Spring split pin
3. Support feet
4. Wheels
5. Drain hose (condensate)
5a. Hose connection (condensate)
6. Handle
7. Display with control panel
8. Maintenance flap (collection bucket)
18 | GB
a. Dehumidification mode
b. Automatic defrosting
c. Speed display
d. Operating hours counter
e. Adjust speed
f. Reduce target humidity
g. Increase target humidity
h. On/off switch
i. Hygroscope
3. Scope of delivery
Item Quantity
1. 1x
1a. 4x
5. 1x
1x
1x
4. Proper use
The product is intended for 230 V AC voltage devices.
Be sure to observe the restrictions in the safety
instructions.
The product is only suitable for indoor use, for drying
damp walls, after water damage or for reducing the
humidity in closed rooms larger than 10.1 m².
The product may only be used in the intended man-
ner. Any use beyond this is improper. The user/opera-
tor, not the manufacturer, is responsible for damages
or injuries of any type resulting from this.
An element of the intended use is also the obser-
vance of the safety instructions, as well as the as-
sembly instructions and operating information in the
operating manual.
Persons who operate and maintain the product must
be familiar with the manual and must be informed
about potential dangers.
The liability of the manufacturer and resulting dam-
ages are excluded in the event of modifications of the
product.
The product may only be operated with original parts
and original accessories from the manufacturer.
The safety, operating and maintenance specifications
of the manufacturer, as well as the dimensions speci-
fied in the technical data, must be observed.
Please note that our products were not designed
with the intention of use for commercial or industrial
purposes. We assume no guarantee if the product is
used in commercial or industrial applications, or for
equivalent work.
www.scheppach.com
Designation
Handle
Hexagonal bolt M6x35mm
Condensate drain hose
Building dryers
Operating manual