Sound-Control; Connection With The Dimmerpacks/Projectors; Operation - EuroLite Stage Control 136 Bedienungsanleitung

Rack-installation: This device is built for 19" racks (483 mm). The rack you use should be a Double-Door-
Rack where you can open the frontpanel and the rear panel. The rack should be provided with a cooling fan.
When mounting the controller into the rack, please make sure that there is enough space around the device
so that the heated air can be passed on. Steady overheating will damage your device.
You can fix the controller with four screws M6 in the rack.
Connect the connection cable of the power-unit with the DC IN-socket. Plug the power unit into your outlet.

5.2 Sound-control

The sound-control works via the built-in microphone or via the sound input socket.
Connect the sound-signal from the mixer (e.g. Master 2) with the Jack-socket on the rear panel (input
sensitivity 0.1 V - 1 V).

5.3 Connection with the dimmerpacks/projectors

DMX-512:
The wires must not come into contact with each other, otherwise
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
Occupation of the XLR-connection:
You can adjust the XLR polarity via the DMX POLARITY selector.
Building a serial DMX-chain:
Connect the DMX-output of the Stage Control 136 with the DMX-input of the nearest dimmerpack. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.
Projector addressing
Please note that the Stage Control assigns the DMX-starting addresses every 16 steps. You have to address
every projector to the respective starting address. Otherwise, the channel assignment will not be correct. All
projectors with the same starting address work synchronically.
Projector Starting address
Projector 1 1
Projector 2 17
Projector 7 97

6. OPERATION

Install the device on a plane surface.
Connect the connection cable of the power-unit with the DC IN-socket. Plug the power unit into your outlet.
With the POWER-switch, you can switch the device on and off.
the fixtures will not work at all, or will not work properly.
Projector
Projector 3
Projector 4
Projector 8
Starting address Projector
33 Projector 5
49 Projector 6
113
23/30
resistor
Starting address
65
81
00028844.DOC, Version 1.0