EuroLite Stage Control 136 Bedienungsanleitung Seite 29

Select mode 100 or mode 255 by UP/DOWN buttons. "100" is for value in percents (%), "255" is for values in
DMX steps. Press "RECORD" to confirm your operation, use "ESC" to cancel or exit.
MIDI channel
Enter the setting mode and choose "5. MIDI CH.", then press RECORD button (15) to enter the relevant
further operation. LCD will show you:
Select relevant MIDI channels (1-16) by UP/DOWN buttons.
Press "RECORD" to confirm your operation, and use "ESC" to cancel or exit.
Notice for CF card
Do not pull out the CF card when being used.
Power must be assured "on", when reading or storing to CF card.
Turn off the power when connect or disconnect CF card with the unit.
CF card (32MB) can be used only for Stage Control 136; otherwise the data would probably be missing.
Outputting of DMX would be stopped during the reading or storing to CF card. And so does to "ASSIGN CH."
mode.
CF card may become hot during use. Please observe due caution when removing memory cards from this
device.
Take good care of the CF card, and keep it in good conditions.
To clear the memory
Turn off the power, simultaneously holding down the Chase buttons 3, 6 and the Fixture buttons 2, 7, and at
the same time, turn on the power.
LCD will show you :
Memory will be cleared within 5 seconds.
MIDI Implementation
This unit can receive and transmit MIDI NOTE information according to the relevant channels. Please keep
the following list for reference.
NOTE NUMBER FUNCTION
23-34 FIXTURE PAGE 1-12
35-50 PAR PAGE 1-16
51-58 FIXTURE SCENE 1-8
59-66 FIXTURE CHASE 1-8
67-72 PAR SCENE 1-6
73-78 PAR CHASE 1-6
79 PAR STANDBY
80 PAR FADE + SPEED
81 FIXTURE BLACKOUT
82 FIXTURE AUDIO
83 PAR AUDIO
84 PAR AUTO
85 PAR STEP
86 FIXTURE MIX/SEQ
87 PAR ONE/MIX/SEQ
88 PAR FULL ON
MIDI CH. <X X>
OK ESC CHANGE
CLEAR MEMORY NOW
PLEASE WAIT.
29/30 00028844.DOC, Version 1.0