Set Up Moving Light Effects; Programming And Controlling A Moving Light Effect - EuroLite Stage Control 136 Bedienungsanleitung

Set Up Moving light effects

DMX channels 1 to 113 are reserved for the movinglights. Channels 129 to 136 are reserved for the static
DMX channels, at the Parcan section (B) of the Lightdesk Pro 136.
Before you start programming, the console first has to be patched.
Hold down the SETUP button (11) for 5 seconds, the green LED will illuminate.
With the UP/DOWN buttons (17 & 18) you have to choose "2. ASSIGN CH" and then press the RECORD
button (15).
The LCD now shows:
This means Controller Channel 1 now sends a signal to DMX address 1. You can change the DMX address
by pressing the DOWN button (18), until you see the address you want. By pressing the UP button (17), you
can change the Channel of your Stage Control 136. To save a channel patch, you first have to select a
fixture (3) and then press RECORD (15). Make sure all channels are only used once.
After the display shows:
The joystick patch starts with:
The joystick of the Stage Control 136 is not standard included in the patch, that's why the word "NONE" is
shown on the spot of the DMX address in the display.
You can change the address by using the DOWN button (18). Press the button, until the display shows the
right DMX address. Now press UP (17), until the display shows: TILT >NONE and then patch the TILT
address. Now select the FIXTURE (3), for which the joystick will be patched. Then press RECORD (15), the
LEDs will flash a moment and the display shows: "GOOD", meaning the patch has been stored.
When, during the steps above, the display shows "ERR", means an error has been made with patching,
example: The patch address is already used, no double channels can be patched.
Follow all steps, until all channels have been set. Then press the ESC button (16) to exit the menu.

Programming and Controlling a Moving Light Effect

Hold down the RECORD button (15) for 5 seconds, the green LED will illuminate.
The LCD now shows:
Push the PAGE button (5) and use the UP/DOWN buttons (17 & 18) to change the PAGE number, on which
the "scene" or "chase" will be programmed. There are 12 pages and on every page 8 chases and 8 scenes
can be programmed. Remember which "chases" are on which page, this makes it a lot easier.
Scene
Select the SCENE (1) and FIXTURE (3) you want to program. By using the faders (4) you can set the
preferred set up. When everything has been set to your need, press the RECORD button (15) to confirm and
all LEDs will flash for a moment. Repeat these steps, until all scenes are programmed.
Chase
Select the CHASE (2) you want to program. Make sure that the "chase" you want to program, is actually
selected. By using the faders (4) you can set the preferred set up. When everything has been set to your
need, press the RECORD button (15) to confirm and all LEDs will flash for a moment. Repeat these steps,
until all steps are in the chase. Press the DEL button (13) to delete the current step, all LEDs will flash once.
CHANNEL01>OUT01
OK ESC SEL ADJ
CHANNEL16>OUT16
OK ESC SEL ADJ
PAN>NONE
OK ESC SEL ADJ
SELECT A SCENE OR CHASE! PAGE01
24/30 00028844.DOC, Version 1.0