Crivit FC-13564 Bedienungsanleitung Seite 23

Note: the batteries must be completely inside
the battery holder�
Note: make sure that the sealing ring is
always properly attached to the battery com-
partment cover�
5� Using a coin, screw the battery compart-
ment cover clockwise to close the battery
compartment�
6� Press and hold the 'SET' button (16) to
return to normal operation mode�
Note: after removing the batteries, all of the
data is deleted (new basic settings for the
product are necessary)�
Replacing the batteries
The bicycle computer (1) battery must be re-
placed when the battery status indicator (11) is
shown on the display� The sensor (4) does not
have a battery status indicator�
First press and hold the 'MODE' button (15),
simultaneously hold the 'SET' button (16) and
hold both down until the battery symbol and
{{–}} are shown on the display�
Proceed as described in the section 'Remove
protective strips/insert batteries'� Remove the
old batteries from the battery compartments
before inserting new batteries�
GB 23