Herunterladen Diese Seite drucken

ULTIMATE SPEED UAWSB 2 C2 Bedienungs- Und Sicherheitshinweise Seite 11

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 20
electrical voltage in 6 Volt operating mode is
approximately 6.1 Volt and in 12 Volt operating
mode it is approximately 12 Volt. It is recommended
that the battery is recharged.
If the "fully charged" LED lights up, then the battery
is fully charged and ready to start. In this LED status
the electrical voltage in 6 Volt operating mode is
approximately 6.4 Volt and in 12 Volt operating
mode it is approximately 12.6 Volt.
Attention: Please refer to the operating instructions
about the maintenance of the battery prior to charging!
Please note: If no LED lights up in 6 V operating
mode, then it can be assumed that the battery is defec-
tive or deeply discharged. If an LED in the 6 V operating
mode lights up when a 12 V battery is connected, then
it can be assumed that the battery is deeply discharged
or defective.
z Alternator test
Connect the device to the battery as described under
"Operation".
Start the engine and switch on all consumers
(headlights, radio, heated rear window, etc.).
Briefly increase the idle speed to 2500 RPM.
If the "charging function O.K." LED to "charging
function MAXIMUM" lights up, the alternator or volt-
age regulator is OK. In this LED status the electrical
voltage in 6 Volt operating mode is approximately
GB/IE/NI/CY/MT
11

Werbung

loading

Diese Anleitung auch für:

497435 2204