Acoustic Signals - Electrolux TTC1004 Benutzerinformation

How to deactivate the rinse aid
empty notification
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
start flashing and the display is blank.
2. Press .
• The indicators
are off.
• The indicator
• The display shows the current
setting:
notification is activated (factory
setting).
3. Press to change the setting.
= the rinse aid empty notification is
deactivated.
4. Press on/off to confirm the setting.

6.5 Acoustic signals

Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic signal
is deactivated but it is possible to
activate it.
How to activate the acoustic
signal for the end of
programme
The appliance must be in programme
selection mode.
1. To enter the user mode press and
hold simultaneously
the indicators
flash and the display is blank.
2. Press
• The indicators
are off.
and until
, , , and
, , and
still flashes.
= the rinse aid empty
and until
, , , and
, , and
• The indicator
• The display shows the current
setting:
3. Press to change the setting.
= Acoustic signal on.
4. Press on/off to confirm the setting.
6.6 AutoOpen
AutoOpen improves the drying results
with less energy consumption.
While the drying phase
operates, a device opens the
appliance door. The door is
then kept ajar.
CAUTION!
Do not try to close the
appliance door within 2
minutes after automatic
open. This can cause
damage to the appliance.
CAUTION!
In case of presence of
children, the AutoOpen
system can be deactivated if
you want to keep the door
closed in the end of the
cycle.
AutoOpen is automatically activated with
all programmes excluding Rinse & Hold
To improve the drying performance refer
to the XtraDry option or activate
AutoOpen.
ENGLISH
still flashes.
= Acoustic signal off.
11