Werbung
HP ProCurve
Power Supplies
Description
The HP ProCurve Switch zl Internal Power Supplies (J8712A, J8713A or
J9306A) are redundant power supplies that you can add to any of the HP
ProCurve zl switches to provide additional switch reliability.
supplies can also be used with the HP ProCurve Power Supply Shelf (J8714A)
to provide additional POE or PoE+ power to any of the zl switches.
Features:
power redundancy—if
remaining
supply or supplies provide
loaded
5400zl or 8200zl
power load sharing—with
load, which
increases
"hot swap" operation—you
Supplies without having to shut down or reboot the switch.
automatic
fault detection—if
the Switch can immediately
the
Power
Status
and Fault
power supply. Event messages will also be displayed in the switch console
event log and the web browser interface Alert log.
Power and Fault
supplied to the power supply. The Fault LED (orange) is lit when there is
a fault condition
with the power
The three power supplies are different in their input and output power
specifications.
The J8712A and J8713A Power Supplies can be paired within the same switch
or within the Power Supply Shelf.
The J9306A Power Supply can only be paired with another J9306A Power
Supply within the same switch or within the Power Supply Shelf. The J9306A
Power Supply cannot be used with either the J8712A or J8713A Power
Supplies.
Switch
zl Internal
any one of the power supplies should fail, the
the power to continue
switch.
two supplies installed, each shares the power
the life of both of the power
can add or replace one of the Power
the power supply encounters a problem,
detect the condition
LEDs
on the switch
LEDs—The
Power LED (green) is lit when power is
supply.
Description
These power
running a fully
supplies.
and report
it by way of
and the Fault
LED
on the
1
Werbung
