Werbung
Installing the Power Supply
Caution
Center the power supply in the
opening and push it all the way back
until the bulkhead on the power
supply makes contact with the back
face
6
Installation
Steps
Follow these steps to install the power supply into the back of the switch:
1.
Remove
the power
Torx
T-10
screwdriver.
Make sure the AC power is not connected to the power supply being installed
before installing the power supply into the switch. The switch can be receiving
power from the other power supply during the installation
2.
Insert
the power supply into the opening
in the opening. This will assure that the guide rails on the bottom of the
power supply engage the rails on the bottom of the switch. Then, slide the
power supply all the way in until its bulkhead contacts the back face of
the
switch.
of the switch.
Figure 4.
Installing a power supply
supply
slot
cover
with either a flat-bladed
Retain
the
slot
cover
or
for
future
use.
of the second unit.
making sure it is centered
During the installation,
make sure that AC power
is NOT connected
to the
unit being installed.
Werbung
