Werbung
Caution
Troubleshooting
If the Power Status LED and the switch Fault LED are flashing, either the
power supply is not connected to an active AC power source, the power supply
is not properly
installed,
supply.
Verify the power cord is plugged into an active power source and to the
I.
power supply. Make sure these connections are secure. You can verify that
the AC power source is active by plugging a different device into the outlet
and verify that it is receiving power.
2.
If the Power Status LED continues to flash, verify that the fans in the
power
supply are working.
the vent holes. If they are not, try plugging the power supply into a
different outlet, and/or try a different power cord.
3.
If the previous steps do not resolve the problem, try removing and
reinstalling the power supply.
Make sure the AC power cord is disconnected from the supply before
removing and reinstalling the supply.
If the power source and power
switch power supply may be faulty. Call your HP-authorized
use the electronic support services from ProCurve to get assistance. See the
Customer
Support/Warranty
information.
Customer
Support Services
If you are having any trouble with your power supply or switch, Hewlett-
Packard offers support 24 hours a day, seven days a week through the use of
a number of automated electronic services. See the Customer Support/
Warranty booklet that came with your switch or power supply for information
on how to use these services to get technical support. The ProCurve
networking
products Web site, www.procurve.com
support information.
Additionally,
your ProCurve authorized network reseller can also provide you
with assistance,
both with services that they offer and with services
by ProCtuve.
or a fault condition
has been detected
If they are, you can feel air being blown
cord are 0K and this condition
booklet
supplied with the power supply for more
Troubleshooting
on the power
out of
persists,
the
LAN dealer, or
also provides up-to-date
offered
9
Werbung
