Werbung
Installation
Cautions:
Make sure the power source circuits
supplied with the power supply to connect it to the power source.
If your installation requires a different power cord than the one supplied with the power supply,
be sure the cord is adequately sized for the switch's current requirements. In addition, be sure
to use a power cord displaying the mark of the safety agency that defines the regulations for
power cords in your country. The mark is your assurance that the power cord can be used safely
with the power supply.
When installing the switch, note that the AC outlet should be near the switch and should be
easily accessible
in case the switch
Ensure the power supply does not overload the power circuits, wiring, and over-current
protection.
To determine
ampere ratings of all devices installed on the same circuit as the switch with this power
supply and compare the total with the rating limit for the circuit. The maximum ampere
ratings are usually printed on the devices near their AC power connectors.
Do not install the power supply into a switch that is in an environment
ambienttemperature mightexceed550C (131 OF) I . Ifthe powersupplyisinstalledin a8212zl
chassis, the ambient temperature must not exceed 400C (1040F). If the power supply is
installed in a 8206zl chassis, the ambient temperature must not exceed 450C (117 OF).
Make
sure
the
air flow
Make sure that for any switch power supply slot into which a power supply is not installed,
the cover plate is installed to cover the slot. A cover plate is required for safe operation,
and to ensure proper switch cooling
The switch power supplies are hot swappable; they can be installed or removed while the switch
is receiving power from the supply in the other slot. But, as indicated by the caution statement
on the power supply, the supply must not be connected
or removed.
CAUTION:
1
If you are installing any of the X2 transceivers the operating ambient temperature should not exceed 400C
(1040F). Seetransceiver specifications in Appendix A, of the HP ProCurve Series 8200zl Switch Installation
and Getting Started Guide.
Installing the Power Supply
are properly
must be powered
the possibility
of overloading
around
the
sides
•
to the installation
guide for proper power cord selection
' Disconnect
AC power from the power supply BEFORE installing
removing the supply. Otherwise, damage to the equipment
grounded,
then use the power
off.
the supply circuits,
and
back
of the
switch
to AC power before being installed
Installing the Power Supply
cord
add together
where the operating
is not
restricted.
or
may result.
the
5
Werbung
