Werbung
Installing the Power Supply
Note
8
The Switch zl Internal Power Supply does not have a power switch. It is
powered on when the power cord is connected to the supply and to a power
source.
Please see the "Installation
6.
Verify the power supply is installed
on the front ofthe switch. The following example shows an 8206zl switch.
Figure 6.
Switch Power Status and Fault LEDs
The Power
Status LED for the power
flashing simultaneously
connected to an AC power source. Once it is connected to AC power, the
Power Status LED will be on continuously
will stop flashing.
If the Power Status LED and the switch Fault LED continue flashing after the
power supply is connected to AC power, see "froubleshooting"
page.
Cautions" on page 5.
correctly
supply you have just installed
with the Fault LED until that new power supply is
and not flashing, and the Fault LED
by checking the LEDs
will be
on the next
Werbung
