Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating mode and charging current can be changed as
the charge process is running. Any change of operating mode
resets
the recorded
9.
Charge mode.
The charger has six independent charging slots. It allows to
charge different cells, sizes, capacities in different (from Ipc to
6pcs) quantity at the same time. All compatible batteries are
automatically charged (except the LiFeP04 and Li-HV, which
have to be selected manually). The charge process is strictly
controlled and terminated with very good precision (the
termination method depends on battery type). When the
operation is finished, the full battery symbol is visible next to
corresponding
by 'End' label on LCD when showing the status of selected
battery slot. Each battery status can be reviewed by pressing
SLOT button. The display shows a wide variety of information:
charged capacity (not actual cell's capacity), time, voltage and
charge percentage.
NOTE: we recommend
than 1000mAh
Charging
with 1000mA current
10.
Discharge
Press the MODE button shortly to select DISCHARGE
mode. There are two discharge currents to choose: 200mA and
400mA The end voltage depends on battery type. When the
entire process is completed the empty battery will occur next to
corresponding
charged! It's not recommended to leave cells in discharge state.
Finished process ISalso Indicated by 'End' label on LCD. For a
12
data for all inserted
slot number. Finished process is also indicated
that batteries
are charged
mode.*
slot - C4. In this process the battery won't be
batteries
with a capacity
only by using
may shorten battery's
of less
500mA
setting.
life.
Werbung
