Werbung
Verfügbare Sprachen
Verfügbare Sprachen
When inserting next batteries into the charger, the LCD will
always show the status of the last inserted cell. The user can
manually review other battery compartments
button.underestimated
If no further action is taken by the user, the charger will start
the charge process with default settings —with 500mA current
for
slots
CI-C4
8.
Selecting
charging
Charger has an unique function that can test the internal
resistance (IR) of inserted cells. The test is carried out
automatically just after the battery is placed in any of the slots
This is very usefull to determine in what condition is the battery.
Together with capacity test it's all you need to have a full
knowledge about your battery health. Please note that the IR
measurement is very sensitive and there can be some
measurement
charger can be a bit too optimistic, especially with Li-ion
batteries. The IR results tend to increase due to aging of
batteries and charger (due to increased contact resistance). As
for the consumer grade charger the IR results are very accurate
and allow to easily compare the cells between each other. For
optimum results the battery should be charged in about 30-70%
Measuring the IR on the discharged or nearly charged battery
may bring false results.
How to read IR results (lower is better):
Ni-MH
<70 mQ —high quality/new cell < 30 mQ high quality/new cell
with high output capabilities,
70-200
mQ — increased
internal resistance,
10
and
120mA
operating
currsent.
errors for example
limited
for
9V slots
1-2.
modes and adjusting
the IR result obtained
Li-based
with high output capabilities,
30-150 mQ typical cell for low
drain applications or a cell with
by pressing SLOT
in a new
Werbung
