Werbung
Verfügbare Sprachen
Verfügbare Sprachen
performance in high drain
applications, less reliable
operation,
200-500
mQ
recommended
cycles and check the value
again. If there is no
improvement the cell is worn
out and may be used only in low16340/18650/21700
power devices, but it is
recommended to dispose such disposed.
battery,
>500
mQ
- it is recommended
to run refresh cycles and check
the value again. If there is no
improvement the cell is
completely worn out and should
be disposed,
To make sure the obtained
the contacts / metal parts of the charger and battery are clean. It
IS recommended
repeatable it can be considered as valid. It is always good to
have a reference battery of the same type, with known low IR
value to compare the results.
The default operating mode of UC-4200 is charging
(CHARGE) with a current of 500mA for slots CI-C4 and 120mA
for 9V battery type. Charging current can be altered for all type
of batteries by pressing MODE button for I-2s. Operating modes
can be changed only for slot C4 and it can be choosen from:
charge, discharge, refresh and test.
- it is
to run
refresh
to make
few
integrated PCM (electronic
protection module)
150-250
mQ
internal
resistance,
be used in high drain
applications,
>250 mQ
very high result for a Li-based
one
of these
IR results are valid, make sure
measurements
- increased
should not
not a typical and
cell —being
the
cell
should
if the
value
be
is
11
Werbung
