IKA C-MAG HS 4 digital Betriebsanleitung Seite 15

Accessories
Stirring organs
stirring bars: Ø 6 mm, length to 15 mm
Ø 8 mm, length to 50 mm
Ø10 mm, length to 80 mm
Any other accessories
RSE stirring bar remover
RS1 stirring bar set
H15 bath top
H28 bath top
H16V support rod
H38 holding rod
H44 cross sleeve
Assembling the support rod
The support rod is attached using the threaded support bore (H).
• Screw nut M10 on to the support rod as far as the stop
• Screw on the support rod as far as the stop by hand
• Tighten the support rod and nut M10 using a flat wrench
(SW17).
• Use bossheads to assemble accessory parts or
accessory devices.
The appliance is maintenance-free.
Cleaning
For cleaning disconnect the mains plug!
Use only cleaning agents which have been approved by IKA to
clean IKA devices.
These are: water (containing surfactant) and isopropyl alcohol.
Wear protective gloves during cleaning the devices.
Electrical devices may not be placed in the cleansing agent for the
purpose of cleaning.
Do not allow moisture to get into the device when cleaning.
Before using another than the recommended method for clean-
ing or decontamination, the user must ascertain with IKA that this
method does not destroy the device.
Spare parts order
When ordering spare parts, please give:
- device type.
- serial number, see type plate.
- position number and description of spare part,
see www.ika.com.
Repair
Please only send devices in for repair that have been
cleaned and are free of materials which might present
health hazards.
H
For repair, please request the "Safety Declaration (Decontami-
nation Certificate)" from IKA or use the download printout of it
from IKA website at www.ika.com.
If your appliance requires repair, return it in its original packaging.
Storage packaging is not sufficient when sending the device - also
use appropriate transport packaging.
Maintenance and Cleaning
15