Futurelight POS-60 LED TCL POWERSTICK Bedienungsanleitung Seite 24

OPERATION
Connect the effect to the mains and switch it on via the POWER-switch.
Attention: After every 5 POS-60 LED TCL POWERSTICKs, the fixtures must have a renewed connection
with the power mains.
Stand Alone-operation
In the Stand Alone mode, the POS-60 LED TCL POWERSTICK can be used without controller. You can do
without a controller as the features a built-in microphone, which provides automatic sound control.
Disconnect the FUTURELIGHT POS-60 LED TCL POWERSTICK from the controller.
Please refer to the instructions under Control Board, Main functions, menus Mode, Play and Sound.
Master/Slave-operation
The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the POS-60 LED TCL POWERSTICK you can find an XLR-jack (DMX Out) and an XLR-
plug (DMX In), which can be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via a balanced microphone lead.
Connect the DMX OUT-jack with the DMX IN-plug of the next device.
Please refer to the instructions under Control Board.
24/31 00042508.DOC, Version 1.0