Silvercrest SWKD 100 A1 Bedienungsanleitung Und Sicherheitshinweise Seite 25

Start-up
Note: When the heated blanket is used for the first
time, you may notice a smell of plastic; however, this
will disappear after a short time.
To use the heated blanket, first connect the con-
trol unit with the heated blanket using the
1
plug-in connector
Then insert the mains plug into the socket.
Switching on/off/Selecting
the temperature
Switching on:
Set the control unit
to switch on the heated blanket.
Note: The function display
ter switching the heated blanket on.
Switching off:
Set the control unit
heated blanket off.
Note: The function display
Selecting the temperature:
Set the control unit to the highest temperature
setting (setting 6). This will cause the heating
blanket to warm up quickly.
When operating the heated
blanket for several hours, we recommend setting the
control unit to the lowest setting to prevent the
1
body from overheating and to prevent potential
subsequent skin burns or a heat stroke.
Temperature levels
Set the control unit
(see Fig. A).
Level 1: 38 °C ± 12 %
Level 2: 39 °C ± 12 %
Level 3: 41 °C ± 12 %
Level 4: 42 °C ± 12 %
748.546_SWKD100_2023-06-26_02_IM_Lidl_LB8_OS_content.indd 23 748.546_SWKD100_2023-06-26_02_IM_Lidl_LB8_OS_content.indd 23
(see Fig. B).
3
to level 1, 2, 3, 4, 5 or 6
1
will light up af-
2
to level 0 to switch the
1
will go off.
2
to the desired temperature
1
Start-up/Cleaning and care
Level 5: 44 °C ± 12 %
Level 6: 46 °C ± 12 %
The temperatures were determined according to the
test standard EN-60335-2-17.
Automatic switch-off
Note: The heated blanket switches itself off auto-
matically after approx. 180 minutes. The function
display on the control unit
2
flashing.
To switch the heated blanket back on, first select
level 0 and after approx. 5 sec. select the desired
temperature level.
If the heated blanket is no longer used
after the timer expires:
– switch off the heated blanket (level 0),
– unplug from the socket,
– disconnect the plug-in connector
unit from the heated blanket.
1
Cleaning and care
LIFE BY ELECTRIC SHOCK! Before
cleaning the heated blanket, always
unplug the mains plug from the socket and dis-
connect the plug-in connector
trol unit from the heated blanket (see Fig. B).
1
Otherwise there is a risk of electric shock.
Use a dry, lint-free cloth for control unit
cleaning and care.
RISK OF DAMAGE TO THE
PRODUCT OR PROPERTY!
Never immerse the control unit
in water or other liquids. It may otherwise be
damaged.
If the heated blanket is slightly soiled, use a
dampened cloth and a little liquid mild detergent,
if necessary.
RISK OF DAMAGE TO THE
PRODUCT OR PROPERTY! Never
use chemical cleaning agents or
will then start
1
, thus the control
3
DANGER TO
, thus the con-
3
1
1
GB/IE 23
28.06.23 12:17 28.06.23 12:17