Stand-Alone Mode; Control Board; Dmx Mode - EuroLite 52201123 Bedienungsanleitung

Stand-alone Mode

In the Stand Alone mode, the device can be used without a controller. Disconnect the device from the
controller.

Control Board

The Control Board offers several features: you can e.g. set the flash-rate or the starting
address.
Browse through the main menu by pressing MODE. You can change the selection by pressing
UP or DOWN. The functions provided are described in the following sections.
The display shuts off after 30 seconds of inactivity. With the touch of a button it lights up again.
Flash-rate setting
Press the MODE button until the display shows F-0. Select the desired flash-rate (1 - 9) via the UP or DOWN
buttons.
Brightness setting
Press the MODE button until the display shows C-0. Select the desired brightness (0 - 9) via the UP or
DOWN buttons.
Sound Control/microphone sensitivity setting
You can do without a controller as the device features a built-in microphone, which provides automatic sound
control. Strobe effects are sound-controlled.
Press the MODE button until the display shows S-0. Select the desired sensitivity (0 - 9) via the UP or
DOWN buttons.
Slave setting
Set the DMX start address 001 on every slave-device. Press the MODE button until the display shows Add.
Select the address 001 via the UP or DOWN buttons.

DMX Mode

You can control the devices individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. The individual channels and their features are listed under DMX-protocol.
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the device will respond to the controller.
Addressing
Press the MODE button until the display shows Add. You can now set the desired address (001 - 512) via
the UP or DOWN buttons.
Controlling:
After having addressed the LED Power Strobe COB DMX , you may now start operating it via your lighting
controller.
Please, be sure that you don't have any overlapping channels in order to control each fixture correctly and
independently from any other fixture on the DMX-chain. If several fixtures are addressed similarly, they will
work synchronically.
Note:
It's necessary to insert the XLR termination plug with 120
proper transmission on the DMX data link.
in the last lighting in the link in order to ensure
21/23 00066966.DOC, Version 1.0