Connection With The Mains; Analog Controller Connection / Connection Between Fixtures; Master/Slave Operation; Operation - EuroLite 52201123 Bedienungsanleitung

Connection with the mains

Connect the device to the mains with the power plug. The occupation of the connection cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
Attention! The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.

Analog controller connection / connection between fixtures

The strobe features two ¼"-jacks for connecting several strobes and a one-channel controller by using
instrument leads and mono jack plugs.
Remote control of the strobe is possible via analogue 10V-signals. Every impulse is followed by a flash. We
recommend to use the Eurolite Strobe Controller. Make sure that you do not connect more strobes like
stated in the user manual of the controller.
The occupation of the mono jacks is as follows:
Tip Signal
Sleeve Ground

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR jack and an XLR plug, which can be used for
connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX-cable. Connect the OUT jack
with the IN plug of the next device.
Set the DMX start address 001 on every slave-device.

OPERATION

After you connected the effect to the mains, the strobe starts running.
The LED display lights up and you can choose the desired mode via the buttons MODE, UP, DOWN.
The device has two operating modes. It can be operated in Stand Alone or in DMX-controlled mode.
- STAND-ALONE MODE
Setting flash-rate (F-1 – F-9)
Setting brightness (C-0 – C-9)
Sound Control / Sensitivity (S-0 – S-9)
Slave Setting (Add 001)
- DMX MODE (Add 1-512)
International
L
N
20/23 00066966.DOC, Version 1.0