Herunterladen Diese Seite drucken

Crivit FS-15390 Gebrauchsanweisung Seite 8

Vorschau ausblenden Andere Handbücher für FS-15390:

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

• Warning. Dispose of used batteries imme-
diately. Keep new and used batteries away
from children. If ingestion or penetration of
batteries into the body is suspected, seek
medical assistance immediately.
Danger!
• Handle a damaged or leaking battery with
extreme care and dispose of it immediately in
accordance with the regulations. Wear gloves
when doing so.
• If you come into contact with battery acid,
wash the affected area with soap and water.
If battery acid gets into your eye, rinse it with
water and seek medical treatment immediate-
ly!
• The terminals must not be short-circuited.
Inserting/replacing batteries
(Fig. C)
WARNING! Observe the following
instructions to avoid mechanical and
electrical damage.
Remove the protective strip (2d) before using the
product for the first time.
Proceed as shown in Fig. C to insert and replace
the battery (4).
Note: you will need a suitable screwdriver (not
included in the package contents).
Note: pay attention to the plus/minus poles of
the batteries and ensure that they are inserted
correctly. The batteries must be fully inserted into
the battery holder.
Note: ensure that the battery compartment is
screwed tight.
Assembly (Fig. B)
1. Place the plug-in elements (1) in a circle.
2. Connect the plug-in elements by pressing and
holding the push-button (1a). Make sure that
you hear them click into place.
Note: the plug-in element with a contrasting
coloured button should always be connected as
it contains a sensor for counting the rotations.
8
GB
3. Repeat this process until you have a hoop in
your size.
Note: make sure that the hula hoop fits snugly, but
not too tightly around the waist and that all plug-in
elements fit together firmly and do not open.
4. Slide the counter trolley (2) onto the plug-in
elements.
Note: make sure that the display is facing
upwards to read the values.
5. Place the hula hoop around the waist and
close the last two plug-in elements together.
Note: at least 11 plug-in elements must be
plugged together to close the hoop.
6. Adjust the length of the band on the ball
weight (3) using the slider.
Note: the degree of difficulty of the exercise
can be customised by adjusting the length of the
band.
7. Press the push button (1a) of the plug-in ele-
ment if you want to open the hula hoop again.
Disassembly
To disassemble the product, proceed in reverse
order.
Basic position
This product is designed for cardio and full-body
exercise. In particular, it exercises the muscles in
the centre of the body, i.e. the abdominal, waist,
back and pelvic floor muscles.
Note: the special design of the product also
provides a massage effect during exercise.
Use
Press the MOD button (2b) or the RST button
(2c) to activate the counter display (2a).
Note: the product automatically switches to
standby mode if it is not used for more than
four minutes. Pressing a button or moving the
counter trolley over the contrast-coloured button
reactivates the counter display. The current mode
is shown on the display.
• Press the MOD button several times to scroll
through the various functions.
• Press the RST button to call up the saved
values or press and hold the RST button for
approx. two seconds to reset the saved values.

Werbung

loading

Diese Anleitung auch für:

Fs-15391488353 2404