Operation - TESTBOY Testavit Schuki 1 LCD Bedienungsanleitung

Operation

Operation
Thank you for choosing a Testavit
| Power socket tester with FI/RCD test (30 mA).
Power socket test
Using the Testavit
correct connection*, or for wiring errors.
The connection status is indicated by the LEDs and can be quickly
and clearly determined in the printed table.
To check to see whether an impermissible, high contact voltage is
applied at the protective earth connection, the finger contact must
be touched. if the LC display thereby illuminates, there is an error.
By activating the button "FI/RCD test" (< 3 sec.), a function check of
the residual current protection equipment (30 mA / 230 V AC) can
be carried out.
* In many international standards it is specified that the phase at a
socket must be applied at the right connection (viewed from the
front).
In Germany, there is no clear regulation for this, because the
Schuko plug is not protected against polarity reversal.
In order to obtain a correct indication and to carry out the FI/RCD
test, the right phase must be applied. Thus, the instrument may
have to be rotated through 180° when checking a Schuko socket
(depending on the wiring).
20
® ®
Schuki 1 LCD , sockets can be checked for
® ®
Schuki 1 LCD.
Testavit
® ®
Schuki 1 LCD