Volume Punch-Through - Hama 2In1 Zapper Bedienungsanleitung

TV
6. Special functions
6.1 Channel Punch-Through
With the channel Punch-Through function, the P+ or P– commands can bypass
the currently controlled device and change the channels of a second device. All
other commands are unaffected.
To activate the channel Punch-Through function:
• Press the desired device button (e.g. TV).
• Press and hold the "P+" button.
• Press the desired device button (e.g. STB).
• Release the "P+" button again (the LED ashes once when the setting is
activated).
To deactivate the channel Punch-Through function:
• Press the desired device button (e.g. TV).
• Press and hold the "P–" button.
• Press the desired device button (e.g. STB).
• Release the "P–" button again (the LED ashes twice when the setting is
deactivated).

6.2 Volume Punch-Through

With the volume Punch-Through function, the V+ or V– commands can bypass
the device currently being controlled
and adjust the volume of a second device. All other commands are unaffected.
To activate the volume Punch-Through function:
• Press the desired device button (e.g. TV).
• Press and hold the "V+" button.
• Press the desired device button (e.g. STB).
• Release the "V+" button again (the LED ashes once when the setting is
activated).
CODES
STB
To deactivate the channel Punch-Through function:
• Press the desired device button (e.g. TV).
• Press and hold the "V–" button.
• Press the desired device button (e.g. STB).
• Release the "V–" button again (the LED ashes twice when the setting is
deactivated).
6.3 Macro Power
Macro Power allows you to switch two AV devices on/off simultaneously.
To activate the Macro Power function:
• Press the desired device button (e.g. TV).
• Press and hold the "Power (13) " button.
• Press the desired device button (e.g. STB).
• Release the "Power (13) " button again (the LED ashes once when the
setting is activated).
To deactivate the Macro Power function:
• Press the desired device button (e.g. TV).
• Press and hold the "Power (13) " button.
• Press the desired device button (e.g. STB).
• Release the "Power (13) " button again (the LED ashes twice when the
setting is deactivated)
7. Learning function
This remote control is equipped with a learning function. This allows you to
transfer functions from your original remote control to this universal remote
control.
7.1 Before you start the learning function
• Make sure that all batteries used in both remote controls are in perfect
condition. Change them if necessary.
• Place your original remote control and the universal remote control next to
each other so that the infrared diodes of the remote controls are directly
opposite each other.
• If necessary, correct the height of both remote controls to achieve optimal
alignment.
• The distance between the two remote controls should be approx. 3 cm.
BIG ZAPPER
ORIGINAL
ca. 3 cm
5