Hama 2in1 Zapper Bedienungsanleitung Seite 7

Note
• Do not move the remote controls during the learning process.
• Make sure that the room lighting is not uorescent tubes or energy-saving
lamps, as these could cause interference and thus hinder the learning
process.
• The distance between the two remote controls and the nearest light source
should be at least 1 metre.
• The learning process is terminated without saving if no button is pressed or
no signal is received for 30 sec. while learning mode is activated.
• In learning mode, each button can only be assigned one function. A new
function overwrites the function previously taught on this button.
• The TV, STB and Setup buttons cannot be assigned new functions.
7.2 Activating the learning mode
1. Press and hold the "Mute (1)
approx. 3 sec. until the status LED lights up continuously.
MUTE
2. Enter the code [9] [8] [0], the status LED ashes 2 times and then lights up
permanently.
3. The universal remote control is now in learning mode.
7.3 Transferring the button function
1. Press the button on the original remote control whose function you want to
transfer. To con rm that the command has been received, the status LED of
the universal remote control ashes.
2. Now press the button on the universal remote control to which the
function is to be transferred.
3. The function LED of the universal remote control ashes 3 times for
con rmation and then lights up permanently again. The new function is
now saved.
4. To transfer the functions of additional buttons, repeat these steps.
5. Press the "Setup (8) " button to save all taught-in functions and BACK
the learning mode.
6
" and [V+] buttons simultaneously for
V+
Note
When changing the batteries of the universal remote control, the functions of
the taught-in buttons are retained.
7.4 Deleting taught functions
7.4.1 Deleting a taught function
1. Press and hold the "Mute (1)
approx. 3 sec. until the status LED lights up continuously.
MUTE
2. Enter the code [9] [8] [1], the status LED ashes 2 times and then lights up
permanently again.
3. Press the button whose function you wish to
want to delete. The status LED ashes 3 times and the desired function
is deleted.
7.4.2 Deleting all taught functions
1. Press and hold the "Mute (1)
approx. 3 sec. until the status LED lights up continuously.
MUTE
2. Enter the code [9] [8] [2], the status LED ashes 2 times and then lights up
permanently again.
3. Press the "Setup (8) " button, the status LED ashes 3 times and all
taught-in functions are deleted.
8. Restoring factory settings
1. Press and hold the "Setup (8)
LED lights up.
2. Press the "Mute (1) "" button. The LED ashes once and then lights up
permanently.
3. Press the number key 0. The LED ashes four times. The remote control is
now reset to the factory settings.
" and [V+] buttons simultaneously for
V+
" and [V+] buttons simultaneously for
V+
"" button for approx. 3 seconds until the