Hama 2in1 Zapper Bedienungsanleitung Seite 8

Note
All taught-in or copied buttons as well as all settings of the remote control will
be deleted.
9. Maintenance
• Never use old and new batteries in the universal remote control at the same
time, as old batteries tend to leak and can lead to a loss of performance.
• Never clean the universal remote control with scouring agents or harsh
cleaning agents.
• Keep the universal remote control free of dust by cleaning it with a dry soft
cloth.
10.Troubleshooting
Q.My universal remote control does not work!
A. Check the AV device. If the main switch on the device is off, the universal
remote control cannot operate the device.
A. Check that the batteries are inserted correctly and that the polarity has been
observed.
A. Check that you have pressed the appropriate device button for the device.
A. Replace the batteries if the battery level is low.
Q.If there are multiple device codes listed for the brand of my AV device, how do I
select the correct device code?
A. To determine the correct device code for the AV device, test the codes one after
the other until most of the buttons work properly.
Q.My AV device only responds to some button commands.
A. Try other codes until most of the buttons work properly.
Q.The brand of my AV device is not mentioned in the code list.
A. In this case, use the manual code search (Section 5.2) or the automatic code
search (Section 5.3). During the code search, all codes for a device type are
tested across manufacturers, e.g. all codes for STB receivers regardless of the
manufacturer.
Q.I have tried all the available codes for the brand of my AV device from the code
list, but none of the codes mentioned work.
A. In this case, use the manual code search (Section 5.2) or the automatic code
search (Section 5.3). During the code search, all codes for a device type are
tested across manufacturers, e.g. all codes for STB receivers regardless of the
manufacturer.
11.Warranty disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for damage
resulting from improper installation/mounting, improper use of the product or
from failure to observe the operating instructions and/or safety notes.
7