imilab EC6 Bedienungsanleitung Seite 8

Connecting the Device
• Turn on the camera
Insert the power supply cable into the camera's power supply port.
Connect the other end of the power supply cable to a power source.
• Insert a microSD
Ensure that the camera
from the power supply. Remove the
waterproof cap and expose the microSD
card slot. Insert the
card slot in the direction
Note: When inserting or removing the microSD card, please disconnect
the camera from the power supply. Please use a microSD card from a
reputable manufacturer.
micro SD card is at least IJI /Class
• Restoring factory settings
Press and hold the reset button with fine needle, then you can hear the
"reset succeed"
deleted.
Note: make sure the waterproof
microSD card or resetting
card
is disconnected
microSD card into
illustrated.
The recommended
10.
voice. Data stored
cover is covered after inserting the
the device.
EN-06
the
O
read and write speed of the
on the microSD card is not