Wilfa INNOBOT Anleitung Seite 18

ROBOT
Do not use wet wipes, detergents, sprays or other chemical products to clean the
EN
sensors, infrared recharging sensors, or charging electrode plates of the robot.
1. Use a soft and clean cloth to wipe the laser distance sensor, infrared lens,
charging electrode plates and cliff sensors.
DUSTBIN STATION
Do not use wet wipes, detergents, sprays or other chemical products to clean the
infrared lens, charging pins and fan filter holder of the dustbin station.
1. When the dust bag is full, open the cover, pull the dust bag upwards to
remove it, throw it in the trash and replace it with a new dust bag. Close
the cover. The cover must be completely closed for the station to function
properly.
2. Use a soft and clean cloth to wipe and clean the infrared lens and the
charging pins to ensure that they are clean and free of debris.
3. Use a soft and clean cloth to wipe and clean the suction inlet to ensure that it
is clean and will make a tight seal against the robot.
4. Check the fan filter holder for any foreign objects or debris wrapped around
it. Use a soft and clean cloth to wipe and clean the holder to ensure it is clean
and free of debris.
Infrared lens
Charging pin
Suction inlet
18
Fan filter holder